Human gait could soon power portable electronics

If the vision of Tom Krupenkin and J. Ashley Taylor comes to fruition, one day soon your cellphone — or just about any other portable electronic device — could be powered by simply taking a walk. In a paper appearing in the journal Nature Communications, Krupenkin and Taylor, both engineering researchers at the University of Wisconsin-Madison, describe a new energy-harvesting technology that promises to dramatically reduce our dependence on batteries and instead capture the energy of human motion to power portable electronics.

“Humans, generally speaking, are very powerful energy-producing machines,” explains Krupenkin, a UW-Madison professor of mechanical engineering. “While sprinting, a person can produce as much as a kilowatt of power.”

Grabbing even a small fraction of that energy, Krupenkin points out, is enough to power a host of mobile electronic devices — everything from laptop computers to cell phones to flashlights. “What has been lacking is a mechanical-to-electrical energy conversion technology that would work well for this type of application,” he says.

Current energy harvesting technologies are aimed at either high-power applications such as wind or solar power, or very low-power applications such as calculators, watches or sensors. “What’s been missing,” says Taylor, “is the power in the watts range. That’s the power range needed for portable electronics.”

Solar power, the researchers explain, can also be used to power portable electronics, but, unlike human motion, direct sunlight is usually not a readily available source of energy for mobile electronics users.

In their Nature Communications report, Krupenkin and Taylor describe a novel energy-harvesting technology known as “reverse electrowetting,” a phenomenon discovered by the Wisconsin researchers. The mechanical energy is converted to electrical energy by using a micro-fluidic device consisting of thousands of liquid micro-droplets interacting with a novel nano-structured substrate.

This technology could enable a novel footwear-embedded energy harvester that captures energy produced by humans during walking, which is normally lost as heat, and converts it into up to 20 watts of electrical power that can be used to power mobile electronic devices. Unlike a traditional battery, the energy harvester never needs to be recharged, as the new energy is constantly generated during the normal walking process.

The initial development of this technology was funded by a National Science Foundation Small Business Innovation Research grant. Now Krupenkin and Taylor are seeking to commercialize the technology through a company they’ve established, InStep NanoPower.

In their work, Taylor and Krupenkin were inspired by severe limitations that current battery technology imposes on mobile electronics users. As any cellphone or laptop user knows, heavy reliance on batteries greatly restricts the utility of mobile electronic devices in many situations. What’s more, many mobile electronics are used in remote areas of the world where electrical grids for recharging batteries are often not available. Cellphone users in developing countries often have to pay high fees to have cellphones charged. Similar problems face military and law enforcement personnel. Modern soldiers, for example, head into the field carrying as much as 20 pounds of batteries to power communications equipment, laptop computers and night-vision goggles.

The energy generated by the footwear-embedded harvester can be used in one of two ways. It can be used directly to power a broad range of devices, from smartphones and laptops to radios, GPS units, night-vision goggles and flashlights.

Alternatively, the energy harvester can be integrated with a Wi-Fi hot spot that acts as a “middleman” between mobile devices and a wireless network. This allows users to seamlessly utilize the energy generated by the harvester without having to physically connect their mobile devices to the footwear. Such a configuration dramatically reduces power consumption of wireless mobile devices and allows them to operate for much longer time without battery recharge, the Wisconsin researchers say.

“You cut the power requirements of your cellphone dramatically by doing this,” says Krupenkin. “Your cellphone battery will last 10 times longer.”

Even though energy harvesting is unlikely to completely replace batteries in the majority of mobile applications, the UW-Madison researchers believe it can play a key role in reducing cost, pollution and other problems associated with battery use. The hope, they say, is that the novel mechanical to electrical energy conversion process they pioneered can go a long way toward achieving that goal.

Source: University of Wisconsin-Madison

16 Comments

  1. Beautiful post! Innovation in the acreage of electronics is absolutely
    amazing. What may be a fiction of bygone can be the absoluteness of
    tomorrow. 

  2. Good information. And i alway like to read the quality content. And i am really happy to found this information on your blog. Thanks for sharing this opportunity to leave a comment.Your blog is awfully appealing.

  3. hey this is really impressive. I read the article and i want to give you thanks for this nice post.
     

  4. Health and wellness products are aimed to promote a healthy lifestyle by catering to the physical, i am very impressed. thanks for good health.

  5. I read this Interesting  article today and watched many funny videos which made my day. thanks a lot.

  6. Interesting post.You have manage & compiled really an informative & unique information. Its really important to us.Interesting I found this blog by accident. Really glad I did though, I’ll be back from now on.

  7. Very interesting. I hadn’t thought of some of these Interesting piece. It can be difficult to find good blogs nowadays. Found one here though by the looks of things.

  8. This definition of potential, while formal, has little practical application, and a more useful concept is that of electric potential difference,
    and is the energy required to move a unit charge between two specified
    points. An electric field has the special property that it is conservative,
    which means that the path taken by the test charge is irrelevant: all
    paths between two specified points expend the same energy.

  9. Well written article.I appreciate your writing skills.Its great you have done a great job by sharing this informative post with us.I would like to read your more updates.Keep in touch with us in future too.

  10. Right when the first of our ancestors discovered how to make fire and
    stone made weapons and tools, we have continued to evolve and discoverer
    new things.

  11. Great and very descriptive tutorial given in your blog.Really very informative for those wiling to learn flash.Thanks a lot for sharing.

  12. Amazing Themes.Really very beautiful.I liked fully written article alongwith pictures.Many Thanks for sharing such wonderful article with us.

  13. Really great examples regarding electronic.Thanks for sharing such article with us.Keep sharing always article like this in future too.

  14. Use of video for
    electronic purposes is becoming extremely popular now a days. Videos can play a big
    role in enhancing a business’s online presence.Well Thanks for sharing such
    smart article with us.

  15. Great content gives freshness and relevancy to the blog or website to boost the ranking.I like this .Thanks to share this blog.

1 Trackbacks & Pingbacks

  1. Rectenna Converts Radio Waves To Electricity

Leave a comment

Your email address will not be published.


*


Show Buttons
Hide Buttons